For this heart (cone) you need four colours. You must cut out two of the larger shapes and one of each of the smaller. For the heart on the picture I started out inserting the red into the light yellow part and inserted the larger yellow blades in the slid below the smaller red blades as explained for heart #018. Then I started weaving with the red strips. Soon the blue strips were wrapped around the yellow strips where they fit and all weaving was done until only the two last light yellow strips remained. Then the two bright yellow strips were wrapped around the light yellow and the weaving finished. Because the lower part of the strips is wider than the upper you have to role or bend the strips to be able to weave the upper parts. That will make the finished heart look a bit worn and not so crisp. This you may observe on a close up.
